12/23/2023 0 Comments Repetier server androidTo do the above using that system, you’d need to enter this text into that field: Īnd (like last years post), some really important things to note: This allows you to enter in script to do a text-replace in your file, to edit it for you. I slice using Simplif圓D: In a given process, it has a section in its ‘Scripts’ tab, at the bottom, called ‘Additional terminal commands for post processing’. Or, like mentioned in the previous post, you can use your slicer software (if it supports it) to post-process the gcode to add this in where you need. Repetier’s ‘reload filament’ code is so simple (just that one line) compared to Marlin, you can easily enough by hand go into your gcode file, find the line number like this: layer 4, Z = 0.78 During Repetier’s ‘rehome’ operation during the reoload, it basically nukes those coordinates, thus putting an offset into my print. Why was this needed though? You can follow the play-by-play on the Repetier firmware form here, but in a nutshell: In my ‘start gcode’, I move my toolhead to the corner of my buildplate and ‘zero’ it there. But now it works, so we can add it to our gcode file. Now, I can reload filament successfully via the LCD.Īnd via the M600 Mcode: Up until then, whenever I’d try this code (which starts the filament reload process the LCD uses) I’d run into the exact same problem. Or in your Configuration.h set: #define FILAMENTCHANGE_REHOME 0 Via the online configuration tool: In the features tab under the “Filament Change” section, I set the “Homing after Filament Change” to “No Homing”. Long story short: You need to configure the firmware to “not home” after filament reload. Basically ruining the print every time I tried. However, I immediately ran into a problem: After the reload, it wouldn’t return to the correct position on the build plate: It was always offset by some amount. Repetier allows you to ‘Reload Filament’ via the LCD. As it turns out you can, and actually it’s a lot easier… presuming it works in the first place: I figured you could do the same thing in Repetier. gcode script at a given line number to pause it, allowing you to do a filament reload by hand. The above link has a chunk of G and M codes that could be inserted into the. Since then I upgraded (I consider it an upgrade) to Repetier, and wanted to do the same thing. Last year I posted Howto: Pause Marlin for filament reload at a specific layer number.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |